Load data for 9 mm Browning Court (.380 ACP) + .355 | 124gr | Sellier & Bellot LRN

Recommended Powder(s): ReloadSwiss RS 12, Rottweil P 801, Vihtavuori N320

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.355 \| 124gr \| Sellier & Bellot LRN
Manufacturer SKU:	31937
Bullet Weight:	124gr \| 8.0g
Bullet Diameter:	0.355" \| 9.02mm
Bullet Length:	0.575" \| 14.6mm
Caliber:	9 mm Browning Court (.380 ACP) load data
Case Length (l3):	0.681" \| 17.3mm
Cartridge Length (C.O.L.):	0.969" \| 24.6mm
Seated Depth:	0.287" \| 7.3mm
Shank Seated Depth:	0.287" \| 7.3mm
Case Capacity:	12.2 Grains of Water \| 0.79 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	19580 psi \| 1350 bar
LID:	LID_B7248_C1213
Last updated:	2025-01-01

Load data for 72 loads in caliber 9 mm Browning Court (.380 ACP) with .355 | 124gr | Sellier & Bellot LRN bullet and 36 powders such as ReloadSwiss RS 12, Rottweil P 801, Vihtavuori N320. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 70N	<<locked>>	80%	16969	87%	**9	96%
ADI APS 350	<<locked>>	70%	16795	86%	**5	100%
ADI APS 450	<<locked>>	70%	15882	81%	**8	100%
ADI AS 30	<<locked>>	84%	17448	89%	**4	100%
ADI AS 50N	<<locked>>	80%	16404	84%	**7	99%
Accurate Solo 1000	<<locked>>	78%	16505	84%	**4	99%
Accurate Solo 1250	<<locked>>	89%	15447	79%	**4	93%
[Alliant BULLSEYE]*	<<locked>>	75%	15577	80%	**0	87%
[Alliant UNIQUE]*	<<locked>>	93%	15418	79%	**0	86%
Baschieri & Pellagri 100	<<locked>>	84%	15940	81%	**7	97%
Hodgdon Clays	<<locked>>	70%	16810	86%	**5	100%
Hodgdon HP38	<<locked>>	64%	17042	87%	**0	96%
Hodgdon Universal	<<locked>>	88%	16969	87%	**9	96%
Lovex S011	<<locked>>	69%	16041	82%	**7	95%
[Lovex S020]*	<<locked>>	86%	16143	82%	**3	89%
Maxam CSB 1	<<locked>>	96%	16534	84%	**0	94%
Maxam CSB 2	<<locked>>	93%	12879	66%	**3	97%
Maxam CSB 3	<<locked>>	87%	16201	83%	**3	98%
Maxam CSB 4	<<locked>>	83%	16360	84%	**7	99%
Maxam CSB 5	<<locked>>	80%	17579	90%	**7	100%
[Ramshot Silhouette]*	<<locked>>	77%	16462	84%	**0	83%
Ramshot Zip	<<locked>>	63%	16273	83%	**0	95%
ReloadSwiss RS 12 👍	<<locked>>	90%	16897	86%	**9	100%
[ReloadSwiss RS 20]*	<<locked>>	95%	15113	77%	**7	87%
Rottweil P 801 👍	<<locked>>	81%	17114	87%	**3	100%
[SNPE Vectan A0]*	<<locked>>	94%	17202	88%	**7	86%
SNPE Vectan BA 9	<<locked>>	82%	16520	84%	**4	91%
SNPE Vectan BA10	<<locked>>	66%	15867	81%	**8	100%
SNPE Vectan BA9 1/2	<<locked>>	88%	16984	87%	**3	94%
[Somchem MP200]*	<<locked>>	86%	16911	86%	**6	85%
[Somchem MS200]*	<<locked>>	87%	15751	80%	**7	87%
Vihtavuori N310	<<locked>>	69%	17390	89%	**1	100%
Vihtavuori N320 👍	<<locked>>	85%	15954	81%	**0	100%
Vihtavuori N330	<<locked>>	92%	16897	86%	**6	96%
[Vihtavuori N340]*	<<locked>>	91%	15751	80%	**3	86%
Winchester 231	<<locked>>	71%	16273	83%	**0	95%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
[ADI AP 70N]*	<<locked>>	61%	9340	48%	**6	86%
ADI APS 350	<<locked>>	63%	13967	71%	**2	100%
ADI APS 450	<<locked>>	64%	13300	68%	**6	100%
ADI AS 30	<<locked>>	65%	10443	53%	**9	99%
ADI AS 50N	<<locked>>	63%	10283	53%	**6	93%
Accurate Solo 1000	<<locked>>	66%	11980	61%	**2	96%
[Accurate Solo 1250]*	<<locked>>	73%	9848	50%	**2	85%
[Alliant BULLSEYE]*	<<locked>>	65%	11676	60%	**8	81%
[Alliant UNIQUE]*	<<locked>>	83%	11792	60%	**4	81%
Baschieri & Pellagri 100	<<locked>>	67%	9805	50%	**9	91%
Hodgdon Clays	<<locked>>	63%	13895	71%	**9	100%
Hodgdon HP38	<<locked>>	60%	14808	76%	**1	95%
[Hodgdon Universal]*	<<locked>>	68%	9340	48%	**6	86%
[Lovex S011]²	<<locked>>	59%	11734	60%	**9	90%
[Lovex S020]*	<<locked>>	72%	10269	52%	**2	81%
[Maxam CSB 1]*	<<locked>>	73%	9297	48%	**6	84%
[Maxam CSB 2]*	<<locked>>	71%	7078	36%	**9	87%
Maxam CSB 3	<<locked>>	70%	10167	52%	**9	91%
Maxam CSB 4	<<locked>>	65%	9863	50%	**2	94%
Maxam CSB 5	<<locked>>	61%	10254	52%	**6	100%
[Ramshot Silhouette]*	<<locked>>	73%	14562	74%	**4	81%
[Ramshot Zip]²	<<locked>>	59%	14243	73%	**1	93%
ReloadSwiss RS 12	<<locked>>	65%	7731	39%	**6	93%
[ReloadSwiss RS 20]*	<<locked>>	85%	11864	61%	**5	82%
Rottweil P 801	<<locked>>	62%	9210	47%	**2	98%
[SNPE Vectan A0]*	<<locked>>	83%	13329	68%	**1	82%
[SNPE Vectan BA 9]*	<<locked>>	67%	10979	56%	**6	84%
SNPE Vectan BA10	<<locked>>	60%	13285	68%	**6	100%
[SNPE Vectan BA9 1/2]*	<<locked>>	67%	9674	49%	**9	84%
[Somchem MP200]*	<<locked>>	77%	13053	67%	**8	80%
[Somchem MS200]*	<<locked>>	77%	12024	61%	**5	82%
Vihtavuori N310	<<locked>>	63%	14257	73%	**8	100%
Vihtavuori N320	<<locked>>	68%	9718	50%	**5	95%
[Vihtavuori N330]*	<<locked>>	72%	9573	49%	**2	86%
[Vihtavuori N340]*	<<locked>>	81%	11908	61%	**1	81%
Winchester 231	<<locked>>	62%	12285	63%	**8	91%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data